Signed in as:
filler@godaddy.com
Signed in as:
filler@godaddy.com
Engcon's grading bucket – Optimised together with experienced contractors for use together with the tiltrotator. Chamfered corners all round to avoid collisions with house walls and other objects that can potentially be damaged by the rotating bucket. Conical form for easier filling and an angle of 16 degrees between mounting and bottom for easier bucket rotation without losing material.
A new gripper-adapted bucket series has been developed in parallel with the GRD, the detachable gripper, where the rear of the bucket is designed with a recess that aligns with the gripper’s counterhold and consequently functions as an extended support for the item being gripped, such as a pole or pipe.
Engcon deep-digging bucket – Robust construction for tough jobs. A favourite for anyone needing to excavate and dig in difficult conditions where fast penetration and easy filling are prioritised, for example in trenching and other mass transfers requiring capacity. Like all Engcon buckets, the digging bucket has a long floor and cutaway sides to reduce drag when digging.
The bucket can be fitted with the following accessories on request:
* When selecting a tooth kit, Engcon buckets are fitted with the Cat J system as standard equipment. For other tooth systems, check availability with Engcon.
Engcon’s cable bucket – developed for precision excavation with minimal width for e.g. cables or other services requiring narrow trenches. Its deep profile means better accessibility beneath intersecting cables and pipes and also allows deep trenching without the need for the tiltrotator to go below surface level.
Engcon’s cable buckets are available in two models – Standard and tapered (C)
Engcon’s cable buckets are made from high-quality steel. As with other Engcon buckets, the cutters and other exposed wear surfaces have a hardness of 500 Brinell.
Engcon’s water & sewerage bucket – Specially designed for excavating water and sewerage trenches, the bucket has a slightly conical shape and shorter floor which facilitates rotating the bucket in the trench. Like the other buckets in Engcon’s range, the water & sewerage bucket is reinforced with Hardox at the most exposed points.
The Engcon series of riddle buckets is designed for quick, simple sorting. The riddle buckets require no hydraulics; they are built from the highest quality steel where the cutters and steel ribs have a hardness of 500 Brinell – the same high quality that can be found on every Engcon bucket. All for increased efficiency and a long service life.
The SKB sorting bucket is designed to more easily get beneath the material intended for sorting. It has a slightly narrower shape than the Engcon SP sorting bucket and its long base and low side panels make it easier to get beneath e.g. asphalt or other material intended for sorting. The base ribs run along the length of the bucket, allowing material to slide easily in and out.
The SKB sorting bucket requires no hydraulics and is thus ideal for simple sorting where e.g. finer material is required for backfill or some other use. Cutting steel, lower side plates and ribs consist of high-strength wear steel with hardness of up to 500 brinels, which guarantees high efficiency and long service life.